收藏本站
NCP1652, NCP1652A
I p
I spos
+
?
g m = 250 m S
g m
blanking
t LEB
Inst. current A
To PWM
comparator
R CS
I AVG
Current sense
amplifier
V IAVG
blanking
t LEB
To AC error
Inst. current B
To PWM skip
comparator
amplifier
R IAVG
Figure 63. Current Sense Amplifier
I CS + I IN + (eq. 3)
C IAVG +
Caution should be exercised when designing a filter
between the current sense resistor and the IS POS input, due
to the low impedance of this amplifier. Any series resistance
due to a filter creates a voltage offset (V OS ) due to its input
bias current, CA Ibias . The input bias current is typically
60 m A. The voltage offset is given by Equation 2.
V OS + CA Ibias @ R external (eq. 2)
The offset adds a positive offset to the current sense signal.
The ac error amplifier will then try to compensate for the
average output current which appears never to go to zero and
cause additional zero crossing distortion.
A voltage proportional to the main switch current is
applied to the IS POS pin. The IS POS pin voltage is converted
into a current, i 1 , and internally mirrored. Two internal
currents are generated, I CS and I AVG . I CS is a high frequency
signal which is a replica of the instantaneous switch current.
I AVG is a low frequency signal. The relationship between
V ISPOS and I CS and I AVG is given by Equation 3.
V ISPOS
4k
The PWM Output delivers current to the positive input of
the PWM input where it is added to the AC EA and ramp
compensation signal.
The I AVG Output generates a voltage signal to a buffer
amplifier. This voltage signal is the product of I AVG and an
external R IAVG resistor filtered by the capacitor on the I AVG
pin, C IAVG . The pole frequency, f P , set by C IAVG should be
significantly below the switching frequency to remove the
high frequency content. But, high enough to not to cause
significant distortion to the input full wave rectified
sinewave waveform. A properly filtered average current
signal has twice the line frequency. Equation 4 shows the
relationship between C IAVG (in nF) and f P (in kHz).
1
(eq. 4)
2 @ p @ R IAVG @ f P
http://onsemi.com
25
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
NCP1653EVB BOARD EVAL FOR NCP1653
NCP2993FCT2GEVB BOARD EVAL NCP2993 AUDIO PWR AMP
NCP345SNT1G IC DETECTOR OVER VOLTAGE 5TSOP
NCP346SN2T1G IC DETECTOR OVER VOLTAGE 5TSOP
NCP347MTAITBG IC OVERVOLTAGE PROT CTRLR 10WDFN
NCP348AEMUTBG IC MOSFET DRIVER DUAL 12V 10LLGA
NCP360MUTXG IC CTLR USB POS OVP FET 6-UDFN
NCP361MUTBG IC USB OVERVOLT PROT CTRLR 6UDFN
相关代理商/技术参数
NCP1653ADR2 功能描述:功率因数校正 IC Fixed Frequency RoHS:否 制造商:Fairchild Semiconductor 开关频率:300 KHz 最大功率耗散: 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Reel
NCP1653ADR2G 功能描述:功率因数校正 IC Fixed Frequency Current Mode PFC RoHS:否 制造商:Fairchild Semiconductor 开关频率:300 KHz 最大功率耗散: 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Reel
NCP1653ADR2G-CUT TAPE 制造商:ON 功能描述:NCP1653 Series 15 V 6 mA Current-Mode Power Factor Correction Controller SOIC-8
NCP1653AP 功能描述:功率因数校正 IC Fixed Frequency RoHS:否 制造商:Fairchild Semiconductor 开关频率:300 KHz 最大功率耗散: 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Reel
NCP1653APG 功能描述:功率因数校正 IC Fixed Frequency Current Mode PFC RoHS:否 制造商:Fairchild Semiconductor 开关频率:300 KHz 最大功率耗散: 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Reel
NCP1653DR2 功能描述:功率因数校正 IC Fixed Frequency RoHS:否 制造商:Fairchild Semiconductor 开关频率:300 KHz 最大功率耗散: 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Reel
NCP1653DR2G 功能描述:功率因数校正 IC Fixed Frequency Current Mode PFC RoHS:否 制造商:Fairchild Semiconductor 开关频率:300 KHz 最大功率耗散: 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Reel
NCP1653EVB 功能描述:BOARD EVAL FOR NCP1653 RoHS:是 类别:编程器，开发系统 >> 评估演示板和套件 系列:- 标准包装:1 系列:PCI Express® (PCIe) 主要目的:接口，收发器，PCI Express 嵌入式:- 已用 IC / 零件:DS80PCI800 主要属性:- 次要属性:- 已供物品:板